this post was submitted on 05 Feb 2024
350 points (96.3% liked)

Privacy

33459 readers
461 users here now

A place to discuss privacy and freedom in the digital world.

Privacy has become a very important issue in modern society, with companies and governments constantly abusing their power, more and more people are waking up to the importance of digital privacy.

In this community everyone is welcome to post links and discuss topics related to privacy.

Some Rules

Related communities

much thanks to @gary_host_laptop for the logo design :)

founded 5 years ago
MODERATORS
you are viewing a single comment's thread
view the rest of the comments
[–] [email protected] 68 points 1 year ago (4 children)
[–] [email protected] 48 points 1 year ago (3 children)

16% is pretty good. the ones at three to one percent are the weirdos.

[–] [email protected] 21 points 1 year ago

I really hate and avoid when my phone switches into battery saver at 15%, so in my mind 16% is like 1%

[–] where_am_i 10 points 1 year ago (2 children)

To prolong your battery's lifespan you shouldn't let it drain below 20%.

[–] [email protected] 7 points 1 year ago (2 children)

Don't phone battery indicators lie to you now so that 0% displayed is actually about 20% specifically because of this?

[–] [email protected] 4 points 1 year ago

Yes and 100% isn't 100%

People and their batteries though... It's a futile obsession for some. It doesn't matter how much science or logic you throw at them there's always something.

Like how fast charging hasn't for some time done like a full max rate for the entire time to keep heat within tolerances but still some people think doing the work themselves is somehow better thermal management than modern battery controllers to the point they think it will make a material difference.

[–] [email protected] 1 points 1 year ago (2 children)

For a phone, you're probably going to keep it for less than 5 years, so babying the battery really isn't worthwhile since the battery will probably outlast how long you keep your phone for if you just charge overnight every night or fully charge it daily

[–] [email protected] 3 points 1 year ago

Though some of the phone makers are finally getting the message that some of us want to keep a hold of our expensive phones for a long while. My new Pixel 8 has 7 years of security updates, which should work fine for my purposes. I'll probably replace the battery somewhere in there, though.

[–] [email protected] 0 points 1 year ago

On my Pixel 1, I wasn't careful about the battery, regularly draining it fully and then charging it to 100% (and leaving it on the charger for extended periods) and after 18 months, I was already looking into getting the battery replaced due to greatly reduced capacity.

At a friend's suggestion, I installed Accubattery which alerts me whenever the battery is about to go outside the 20-80% window. I almost always unplug from the charger when I get to 80%. That second battery on the Pixel 1 kept most of its capacity for 4 years. Now my mom has that phone, with the same battery, and even though the capacity went down a bit since, it's more than enough for her needs still.

[–] HumanPerson 2 points 1 year ago (3 children)

Also charging it fully but I don't know how important that one is.

[–] where_am_i 4 points 1 year ago (1 children)

Just as important. And most phones these days have a setting to prevent it from charging to 100%. E.g. I set mine to stop at 90%.

[–] HumanPerson 0 points 1 year ago

I run grapheneos which doesn't have that. I think if I get a smart plug I could use an automation in Home Assistant to turn the charger off.

[–] [email protected] 2 points 1 year ago

Very important. Keep it between 20-80 is a good idea. I differs between different battery chemistries though.

[–] [email protected] -1 points 1 year ago

For lithium batteries (phone batteries) it's actually more important than draining to 0. Many studies indicate that the average phone battery should last several thousand cycles while only losing 5-10% of total capacity provided it is never charged above 80%. Minimum % (even down to 0%) and charge rate below 70% is also unrestricted.

The tl;dr is that everytime you charge to 100% is the same as 50-100 charges to 80%. Draining a lithium chemistry battery to 0 isn't an issue as long as you don't leave it in a discharged state (immediately charging).

[–] [email protected] 6 points 1 year ago (1 children)
[–] [email protected] 29 points 1 year ago (2 children)

Here's a hot tip. If you're on android, open the developer settings and turn on "demo mode" before taking screenshots. It makes the battery and signal display as 100% so you don't get judged by internet commenters who don't go outside.

[–] [email protected] 9 points 1 year ago

Or you click that little edit button and crop the top of the image completely off.

[–] [email protected] 5 points 1 year ago (3 children)

so you don’t get judged by internet commenters who don’t go outside.

I also go outside. I just stop using my Phone at 30% to preserve Battery. That's why I judge these People. Turn it off and preserve the Battery.

[–] [email protected] 6 points 1 year ago (1 children)

My phone is constantly either dead or under 40%

[–] [email protected] 2 points 1 year ago

your cue to stop using it as soon as it drops to 30%

[–] [email protected] 4 points 1 year ago (1 children)

Are you trapped in the wilderness? If you've been abducted by hyenas, hoot like an owl twice.

[–] [email protected] 3 points 1 year ago

hoot hoot wolves hoot hoot not hyenas

[–] [email protected] 11 points 1 year ago (1 children)
[–] [email protected] 17 points 1 year ago (2 children)

I literally used the embed link from XKCD's website

[–] [email protected] 3 points 1 year ago (1 children)

That's just for embedding the image, not citing. If it's not clickable by the end user, then an embed link is not a source, merely a delivery method.

[–] [email protected] 4 points 1 year ago (1 children)

That's a problem with your client, not the link

[–] [email protected] 1 points 1 year ago

Perhaps. Regardless, if it's a limitation that most people's clients face, then it is not a reliable method of attribution. Either way, most people just put the source in the title or comment. It's more reliable. Β―\_ (ツ) _/Β―

[–] [email protected] 1 points 1 year ago (1 children)

I have no way of seeing that on my client. Do you see that information on your's?

[–] [email protected] 2 points 1 year ago (1 children)

Not directly on the rendered comment, but if you view markdown for my comment you can see the link to the source.

[–] [email protected] 3 points 1 year ago* (last edited 1 year ago)

No such option sadly.

Edit: select text does it.

[–] [email protected] 5 points 1 year ago

Ignorance is bliss