this post was submitted on 04 Jan 2024
365 points (98.2% liked)
Asklemmy
43970 readers
1291 users here now
A loosely moderated place to ask open-ended questions
If your post meets the following criteria, it's welcome here!
- Open-ended question
- Not offensive: at this point, we do not have the bandwidth to moderate overtly political discussions. Assume best intent and be excellent to each other.
- Not regarding using or support for Lemmy: context, see the list of support communities and tools for finding communities below
- Not ad nauseam inducing: please make sure it is a question that would be new to most members
- An actual topic of discussion
Looking for support?
Looking for a community?
- Lemmyverse: community search
- sub.rehab: maps old subreddits to fediverse options, marks official as such
- [email protected]: a community for finding communities
~Icon~ ~by~ ~@Double_[email protected]~
founded 5 years ago
MODERATORS
you are viewing a single comment's thread
view the rest of the comments
view the rest of the comments
I second the desk chair as a fat crippled IT worker that spends 10+ hours a day in a desk chair. I used to get a new $500ish chair every 3 or so years when it fell apart. This last time I saved up and dropped about 2.5k on a really nice chair rated for 24/7 use by someone much heavier than I am and it’s a life changer for my back, and this thing should last a lot longer
Really depends on what you need. I've been using a $500-600 24/7 rated office chair daily for over a decade and it's still as fantastic as the day I sat in it on the floor.
The $700 one I have at my other desk is good, but not quite as good as the cheaper one, but I didn't sit in it at the show room before getting it either.
Do you have a brand recommendation? I really need to replace my office chair
Yeah, the brand I went with was concept seating. I’m about 6’7” around 400 pounds - fat gut, big bones, decent amount of muscle - was a lineman before I got crippled. I am 100% a fatass, no excuse, but also big in other dimensions as well. Most chairs, even the big and tall ones from staples and the like, will get a bit of a gangster lean after a year or so of use as the chairs base plate slowly warps and tack welds come loose. You can grind it down and patch up the welds, but not much to be done about the plate warp. The concept seating chair I got has a massively thick base plate that seems like it will hold up to a lot more. One other thing I really like about the one I got is that it doesn’t have the most common failure point, the piston. Instead it has a fuck off huge solid threaded shaft that you use to screw the chair to the right height then lock it with a massive lock washer. Additionally it doesn’t recline or move in any other way other than to spin and roll. You can loosen bolts to adjust the fit then tighten them back up, but nothing is easily adjustable with levers and stuff which I love because those are just failure points and I’d much rather spend the time to set it up once Ave never worry about it again
Herman Miller or Steelcase.
I bought a pair of used (probably dot-com-era surplus) Herman Miller Aeron chairs for me and my wife over a decade ago for like $350 (don't remember if that was for the pair or per-chair; either way it was a bargain) and they're still going strong.