3DPrinting

15759 readers

65 users here now

3DPrinting is a place where makers of all skill levels and walks of life can learn about and discuss 3D printing and development of 3D printed parts and devices.

The r/functionalprint community is now located at: or [email protected]

There are CAD communities available at: [email protected] or [email protected]

Rules

No bigotry - including racism, sexism, ableism, homophobia, transphobia, or xenophobia. Code of Conduct.
Be respectful, especially when disagreeing. Everyone should feel welcome here.
No porn (NSFW prints are acceptable but must be marked NSFW)
No Ads / Spamming / Guerrilla Marketing
Do not create links to reddit
If you see an issue please flag it
No guns
No injury gore posts

If you need an easy way to host pictures, https://catbox.moe may be an option. Be ethical about what you post and donate if you are able or use this a lot. It is just an individual hosting content, not a company. The image embedding syntax for Lemmy is ![](URL)

Moderation policy: Light, mostly invisible

founded 2 years ago

MODERATORS

[email protected]

Weird PETG Printing Behavior (imgur.com)

submitted 2 months ago* (last edited 2 months ago) by csm10495 to c/[email protected]

14 comments fedilink hide all child comments

Hey folks,

I'm not sure what I'm doing wrong. I'm printing PETG (https://kingroon.com/collections/petg-filament?) on my Neptune 3 Plus. It's sort of like it starts (almost) ok, sticks to the plate just fine, then a few layers up it seems to almost have inconsistent extrusion (or maybe even trouble pulling the filament?) leading to holes, etc. till the model just falls apart. See linked photos for about where I give up each time.

I'm printing with Cura and 240C printing, 90C on the build plate. 45mm/s (I've gone down from 60mm/s). Retraction on, no z-hop. 60% fan, though I've tried it with 20% and 100% fan as well.

The filament is in a dryer at 55C. Funny enough I printed basically perfectly (without drying, straight out of the bag) with default settings the first time I printed. The second time and on, have had this problem... and have had it in the dryer.

Any ideas would be much appreciated. Thanks!

Edit: In case its useful, I'm printing this piece: https://file.io/D9jxYq4KOrL7 which is a small remix of a piece from https://www.printables.com/model/130507-bolt-action-pen-for-pilot-g2-cartridges

you are viewing a single comment's thread
view the rest of the comments

[–] [email protected] 1 points 1 month ago

Have you cratered your tip recently? I was having lots of problems similar to yours that were solved when I put in a new tip