this post was submitted on 23 Sep 2024
1347 points (97.2% liked)

People Twitter

5392 readers
524 users here now

People tweeting stuff. We allow tweets from anyone.

RULES:

  1. Mark NSFW content.
  2. No doxxing people.
  3. Must be a tweet or similar
  4. No bullying or international politcs
  5. Be excellent to each other.
  6. Provide an archived link to the tweet (or similar) being shown if it's a major figure or a politician.

founded 2 years ago
MODERATORS
 
you are viewing a single comment's thread
view the rest of the comments
[โ€“] ayyy 1 points 3 months ago (1 children)

Mind sharing a photo of how you did this?

[โ€“] [email protected] 1 points 3 months ago

I haven't actually done this, I was just brainstorming. It shouldn't be too hard of a project, though. The easiest would just be an esp32 chip, limit switch, and small battery and power circuit.

You position the switch were the deadbolt latch hits it in the open or closed position (I'd do open personally). Using esphome with homeassistant would make programming it a breeze.

You'd need to figure out a housing, which is why I wish there was an off the shelf product. I might design one eventually, but it shouldn't be a huge lift for anyone who is familiar with 3d modeling.