I've noticed for awhile now that whenever my Ender 3 S1 Pro is running, some of the lights on the same circuit will flicker seemingly in time with changes in X or Y stage movement. I'd guess that it's a combination of these stages causing minor voltage spikes/dips when they accelerate, and certain cheaper LED bulbs don't tolerate those spikes/dips well.
Has anyone else experienced this and implemented a good fix? It seems like some kind of power smoothing/conditioning filter plugged in between the printer and the wall would help isolate it. Most of those devices seem designed to isolate the device from fluctuations in the mains, and I'm not sure if it generally works both ways (seems like it should...)
Googling around most people are blaming similar issues on poor wiring, which I suppose could be the case even though this is a newer house. But I see very little in terms of actual proven effective fixes, even though it sounds pretty straightforward on its face.
Advice / thoughts?
That tweet is so on the nose, if I had read it in isolation, I would have assumed it was someone being ironic or trolling the racists.
The curry bit is stupid (because curry is delicious and smells good), but I could 100% see an Indian comic using the lines about speeches being facilitated by call center and customer satisfaction surveys as part of their set, because the mental image is honestly kind of funny.