Ngl, this will make waching pawpatrol more interesting. All I could come up with was changing the intro song to pawgpatrol
Thanks, so in sv08's case, I'll have to open the bottom and plug the fan into another header before updating printer.cfg just like your example.
The firmware update is a .deb file, I know this, it's a ~~unix~~ debian system!
How about "farkle" to take another term from the motoring world?
It has klipper but not mainline klipper, looking at some firmware updates that might automagically fix this. gotta confirm what I currently have.
I think the important bit people miss here is "was", language changes, it was an insult, now it just means adding shiny stuff to your desktop.
I've been doing some light research and i think it's possible to run the stock fan slower and turn it off when not printing, but it's unclear whether i'd have to plug the fan into a different header or not.
Because the full info is in a private facebook group :bleugh:
Finally got it out of the box, setup, explore the new features, amazed at those, and the extreme exhaust fan noise.
So what do I do with this monster that I couldn't do with my ender 3? yup bag clips.
That must be a some change, harley to yamaha!
Nothing exciting, well rotted fence fell over, had a nice bracing walk before lunch.
Since you provide zero additional context to your question as to your current transport situation or geographical area, I have to believe that you are doing fine as is, and therefore conclude that there is no need for it.
'My' recommendation is thus:
"HELL YA BROTHER"
Surprised at how dry it is this morning (I'm from Cork /tommytiernan). Side gate is destroyed, but that was 90% rot anyway.
Had a sticky float needle in a carburettor. modern fuel is hell on old stuff.
small spin, loads of people didn't turn out because the weather report was bad, they missed out!
not my photo, yoinked it from a friends facebook post, he always has a good camera with him.
Tough week, car broke, rushed out on my bike to rescue her, after the repair, in a hurry forgot about the disc lock and to make it much worse I had moved the bike backwards so had a good run up and really crunched things. Had to really muscle the broken lock off, the only silver lining I suppose was that I had my good tools with me. Raided spare YZF for parts, so maybe in the new year it'll be a pinky? Also (if anyone remembers) that H100 I'm rebuilding, ya, neutrals not where it's supposed to be...
Got it appart! it's the five speed gearbox so I went and blew 520 euro on go faster bits.
The barrel broke, had to resort to a metal pipe and the BFH bashing on the piston to seperate them. everything after the crank is mint.
It seems it died because of the left hand crank seal walking out, I'll 3d print a tool to make sure that's inserted fully and not doing that again.
So next week it'll be shiny bits and the hunt for a suitable chassis.
A side highlight of my week, got to test ride a suzuki goose 350, on paper really heavy, but it was really chuckable, even with tyres from the 90's I was going a bit too hard after 10 minutes :D
I might need more then sandpaper and diesel to revive this 44 year old honda h100a
Been a few months of on/off designing and printing, but it's on four wheels now (the correct offside rear is being printed right now) still loads to do, the temporary diff is too low, leading to the axles falling out and the tyco bandit inspired body is no where near fitting yet.
What kinda writing do you do?