Why buy a can opener when I have a drill press with an end mill :D
Chef Boyardee: Extra galvanized steel chips added for your daily dose of iron and zinc.
this post was submitted on 18 Aug 2023
28 points (96.7% liked)
Machinist
788 readers
4 users here now
From Newcomers to Old Timers, a community united by the Industry of Machining
Rules Don't post illegal stuff
Don't post Porn (no sexy aluminum surface finishes don't count)
Don't be an asshat (harassment, bullying etc.)
If you're going to post NSFW stuff, flag it as NSFW, It's ok to post shop Screwups (blood/cuts) just make sure to flag it as NSFW
and Finally make sure to have a good time :D
founded 2 years ago
MODERATORS
If you wanna open a can but don't have a can opener just put it into the microwave on high for 5 minutes. It will heat up the foon inside and the pressure will gently lift off the lid
You can't just post something like that without documentation! the world needs to know- how many holes before you can get the top open?