3DPrinting

15782 readers

149 users here now

3DPrinting is a place where makers of all skill levels and walks of life can learn about and discuss 3D printing and development of 3D printed parts and devices.

The r/functionalprint community is now located at: or [email protected]

There are CAD communities available at: [email protected] or [email protected]

Rules

No bigotry - including racism, sexism, ableism, homophobia, transphobia, or xenophobia. Code of Conduct.
Be respectful, especially when disagreeing. Everyone should feel welcome here.
No porn (NSFW prints are acceptable but must be marked NSFW)
No Ads / Spamming / Guerrilla Marketing
Do not create links to reddit
If you see an issue please flag it
No guns
No injury gore posts

If you need an easy way to host pictures, https://catbox.moe may be an option. Be ethical about what you post and donate if you are able or use this a lot. It is just an individual hosting content, not a company. The image embedding syntax for Lemmy is ![](URL)

Moderation policy: Light, mostly invisible

founded 2 years ago

MODERATORS

[email protected]

238

The front fell off. (sh.itjust.works)

submitted 10 months ago by p1mrx to c/[email protected]

25 comments fedilink hide all child comments

you are viewing a single comment's thread
view the rest of the comments

[–] [email protected] 2 points 10 months ago

depending on the design, it might be to control air flow around the hot end's cooler block.

it's usually best to have some type of duct go from the fan and around the back of the block rather than just being open air- it keeps the air contained until it does it's job. But again, the only Bambu I saw was at microcenter and I was in a bit of a hurry so I didn't get a good look at it.