Linux

48330 readers

596 users here now

From Wikipedia, the free encyclopedia

Linux is a family of open source Unix-like operating systems based on the Linux kernel, an operating system kernel first released on September 17, 1991 by Linus Torvalds. Linux is typically packaged in a Linux distribution (or distro for short).

Distributions include the Linux kernel and supporting system software and libraries, many of which are provided by the GNU Project. Many Linux distributions use the word "Linux" in their name, but the Free Software Foundation uses the name GNU/Linux to emphasize the importance of GNU software, causing some controversy.

Rules

Posts must be relevant to operating systems running the Linux kernel. GNU/Linux or otherwise.
No misinformation
No NSFW content
No hate speech, bigotry, etc

Related Communities

Community icon by Alpár-Etele Méder, licensed under CC BY 3.0

founded 5 years ago

MODERATORS

[email protected]

Handling USB-attached Hard Drives. Am I doing it wrong? (lemmy.one)

submitted 1 year ago by [email protected] to c/[email protected]

6 comments fedilink hide all child comments

I have a stack of SATA hard drives that I need to erase.

I have a USB drive dock, a box that a drive can be set into that connects to my computer via USB-3.

I am using DD to write zeros to the raw device, in this case, /dev/sdf.

No matter the actual size of the drive dd stops at about 3 to 7 gb. These are 300 gb to 3 TB drives.

I am not mounting the drives, but I do ensure they are visible to the system with lsblk. To change drives I turn off the dock. The drive then disappears from lsblk. When I insert a different drive and turn the dock back on again /dev/sdf re-appears.

Are all my drives bad? If they are I will need to have them "professionally" destroyed at about $25 a drive.

you are viewing a single comment's thread
view the rest of the comments

[–] Dr_Willis 2 points 1 year ago (2 children)

using dd to zero a drive - is not a secure way to delete the data. It could potentially be recovered.

You mount filesystems, but you are accessing the device directly, so you are not using the filesystem, so no need to mount.

As the other comment mentions, it sounds like a controler issue. monitor the output of sudo dmesg -w as you are doing the work on them.

need to have them “professionally” destroyed at about $25 a drive.

A Hammer is about $5 and will destroy them. :)

[–] dack 1 points 1 year ago

For the vast majority of people, writing zeroes to the disk is good enough. Even nation states and other advanced attackers would need a good amount of luck to get anything useful off a single pass zeroed HDD.

If you really need more than that, then there are various standards and recommendations for multiple passes of random/zeros/ones. Or just go the destructive route.

Of course SSDs are a totally different scenario. Writing zeroes is not sufficient or recommended for those. Generally, the secure erase command is the best way. However, this requires trusting that the firmware does that properly. If you don't trust the firmware, destructive is the only option.

[–] [email protected] 1 points 1 year ago

I don't expect I am the target of a nation-state or large corporation.