Free and Open Source Software

713 readers

1 users here now

If it's free and open source and it's also software, it can be discussed here. Subcommunity of Technology.

This community's icon was made by Aaron Schneider, under the CC-BY-NC-SA 4.0 license.

founded 2 years ago

MODERATORS

[email protected]

Self hosted FOSS software (beehaw.org)

submitted 1 year ago by [email protected] to c/[email protected]

149 comments fedilink hide all child comments

I just recently started playing around with an old pc as my homeserver and am curious of any recommendations for lesser known self hostable foss software that you would recommend

you are viewing a single comment's thread
view the rest of the comments

[–] [email protected] 2 points 1 year ago (1 children)

Ooh. I have a RPI 3 that I never use. Maybe I am overcomplicating this. I tried to use it for managing my 3D printers but it was just a hassle. I think it is actually cheaper to get one of those Creality boxes at this point instead of rolling my own.

Plus SBCs are quiet. Okay, I will try it.

[–] [email protected] 2 points 1 year ago (1 children)

Octoprint on a pi is great for 3d printers. You can even use a pi zero of you disable Bluetooth (it uses the better serial chip otherwise). I've never seen the creality boxes. I'll have to look into it.

[–] [email protected] 0 points 1 year ago (1 children)

Yeah, I was using octoprint. I think I just do not understand networking enough to get over random problems I have.

Actually, I got it working. It was fine for one printer, the set the z offset into the bed so that was a no go. Never got the webcam to work, which is most of the reason I wanted it in the first place.

[–] [email protected] 1 points 1 year ago (1 children)

The webcam is... not easy. Or anyway, it worked when I used a raspberry pI with a raspberry pi camera. Now I use some orange pi zeros with USB cameras, and the setup was tricky. Even worse, it seems to change the camera device every few reboots, so it's basically useless. My printer is by my desk though, so it's not a priority for me. If I really wanted a camera i'd probably set up a cheap WiFi camera that exposed a stream and just set octoprint to point to that stream instead of serving a local one itself. I also use a relay to power my printer on and off, and I think if I was going to set it up again i'd just use a smart plug and one of the plugins to turn it on and off.

[–] [email protected] 2 points 1 year ago

Oh, I am glad it is not just me. That is so anmoying.

IP cam seems like a good option, but I already have a bunch of webcams so... meh.