Ask Lemmy
A Fediverse community for open-ended, thought provoking questions
Rules: (interactive)
1) Be nice and; have fun
Doxxing, trolling, sealioning, racism, and toxicity are not welcomed in AskLemmy. Remember what your mother said: if you can't say something nice, don't say anything at all. In addition, the site-wide Lemmy.world terms of service also apply here. Please familiarize yourself with them
2) All posts must end with a '?'
This is sort of like Jeopardy. Please phrase all post titles in the form of a proper question ending with ?
3) No spam
Please do not flood the community with nonsense. Actual suspected spammers will be banned on site. No astroturfing.
4) NSFW is okay, within reason
Just remember to tag posts with either a content warning or a [NSFW] tag. Overtly sexual posts are not allowed, please direct them to either [email protected] or [email protected].
NSFW comments should be restricted to posts tagged [NSFW].
5) This is not a support community.
It is not a place for 'how do I?', type questions.
If you have any questions regarding the site itself or would like to report a community, please direct them to Lemmy.world Support or email [email protected]. For other questions check our partnered communities list, or use the search function.
Reminder: The terms of service apply here too.
Partnered Communities:
Logo design credit goes to: tubbadu
view the rest of the comments
Industrial but guess it counts.
Giant motor is supposed to kick on, run for a moment in reverse, wind down, and then go forward. What is happening instead is it kicks on then the whole system goes into stopped state. Two days on the phone and I can't figure it out, pouring over the code, trying everything.
Suddenly the guy in the field coughs and says "sorry it's really dusty here".
It clicks in my head. I tell him to manually push down on the contactor. He says he feels resistance I tell him that's good and push harder. It give in and I tell him to start again. Works perfectly.
The dust had combined with the internal oil of the contactor making a sludge. The contactor has two coils, a high torque high current one for starting and a low torque low current one to hold. Not much different than a starter in a car. The sludge has stopped the second coil from engaging keeping it locked in high current. Since it was DC the coil kept drawing more and more amps until the power supply couldn't keep the voltage high enough. Which made the PLC halt. When the PLC halted it erased all the temporary bits including the one that said it was running. The PLC stopped telling the contactor to engage and the power went back to normal.
The sequence was maybe a tenth of a second.
Loved how you broke it down even though I didn't understand much
Thanks. Here maybe this
This is a small contactor. When that blue center part goes in 1L1 becomes connected to the 2T1 and the same things happens to the other two. Basically I am using a little bit of electricity to flip a switch on or off. Turning on or off the motor.
The blue center part is what I asked him to push in by hand.