kilted_cyclist
Same! After mine broke I bounced between Samsung and Garmin before landing in a feñix 6 pro sapphire. Battery life is amazing. Watch faces are configurable and Garmin has an application that allows you to build your own faces if you have the time/inclination. And it's damn near indestructible. Going on 3 years daily wear and it still looks like it could be new. Check out the black Friday deals.
I can't add anything concerning stringing that the other comment didn't already cover, so I'll ask about the gaps.
Have you tried upping the flow rate to fill them in? The other option I've used in the past was lowering my Z Offset if the flow was alright.
Keep in mind that changing your flow rate will likely also cause you have to mess with your retraction settings again.
I don't have an offering for the XDA profile that you're looking for, but a potential alternative. Consider the KAM profile as well.
I used the XDA canvas set on a number of boards for about 5 years and recently switched to the KAM Superuser set on my 
. The dishes on the top of the keys are very slightly smaller but the height and general profile are very, very similar.
Thekeeblog has a nifty comparison chart that puts XDA and KAM side by side.
It doesn't meet your 'no assembly's criteria, but I think the BFO from keeb.io ticks most of the other checkboxes.
My worst for coffee has to be dumping the beans in, flicking the switch, and then watching all the grounds just dump straight on the counter cause I didn't put the basket back...
Seconded! I'm right handed but still browse primarily with my left hand.
My mistake. Couldn't tell if it was blue or was grey and looked like blue due to lighting.
I mentioned the difference in battery usage and heat when charging. The date of purchase and model may make a difference though. Bought mine at the end of 2021. This is a good article to get some info going into it. I did the online chat with Sony. Good luck!
Yepp. The WF-1000XM4 battery issue.
That was one of my fears as well. Thankfully, the issue is so wide spread that they are replacing them outright even after the warranty has elapsed. Sony WF-1000XM4 has an issue where one of the buds drains 5 times faster than the left. Started with firmware 1.4 or 1.4.2.
Kind of? If that makes sense. It's less a feeling of accomplishment and more relief cause it isn't hanging over my head anymore.
May not be pretty, but it's working really well. Bottom to top: plastic screw, nut to tension it against the plate, standoff into the brass heatset inserts.
