Have you confirmed if qBit deploys properly without a VPN enable? If so, you could go into qBit without the vpn and try disabling the "Use UPnP / NAT-PMP port forwarding from my router" in Tools > Options > Connection, then try deploying it again.
Hmm… are you using the community version of Tailscale? Since, I've never had to enable host networking for any of my apps, and I've been able to access all of them through Truecharts Tailscale app while still retaining access to my SMB shares. Also, this may sound silly, but have you double-checked your routes in the Tailscale app?
After looking around, you might be facing an issue with Flatpak permissions. Here's a comment I found on Reddit created by u/avamk where they solved the same issue.
All right, after much trying I installed Flatseal and enabled the Firefox Flatpak's access to my home folder.
After this, it created the expected profile folder under ~/.mozilla/firefox/. I put my custom userChrome.css into that profile folder, and >enabled it in my about:config under toolkit.legacyUserProfileCustomizations.stylesheets per these instructions.
With all of these, the custom userChrome.css is finally working!
Link to original post: https://libreddit.tiekoetter.com/r/firefox/comments/rq40cj/cant_find_profile_folder_for_firefox_flatpak_on/
I'd love to read your explanation for each distro's ranking.
As someone else has pointed out, it really depends on your use case. Although I personally keep my drives (SSD & HDD) in a redundant RAID configuration as my data is largely mission-critical.
It uses QMK with a custom layout.
Not OP, but I also use flat keycaps, so I thought I'd chime in. I'm not really sure why your hands would hurt with flat keycaps, but one of the reasons I chose to use flats were to allow for easier chording with Plover.
Yeah, having the split is super nice, personally I use a BFO-9000 PCB with 3D printed keycaps and case.
Looks nice! I daily drove something like this for a couple of years, then transitioned to a split ortholinear layout, so a bit different but pretty much the same thing.
Due to the relatively small size and overall complexity/tolerances required for the object, I wonder how it would have turned out if done on an SLA printer.
Currently, none. I used to use Netflix, Prime video and Spotify, but when they started removing some of my favorite content I went fully local.
Whoops, you found me. :P