1
I'm running a custom loop with the same processor. About 32C idle and under load is around 50C
this post was submitted on 10 Nov 2023
1 points (100.0% liked)
Intel
24 readers
1 users here now
Rules
-
Be civil. Uncivil language, slurs, and insults will result in a ban. If you can't say something respectfully, don't say it at all.
-
No Unoriginal Sources, Referral links or Paywalled Articles.
-
All posts must be related to Intel or Intel products.
-
Give competitors' recommendations only where appropriate. If a user asks for Intel only (i.e. i5-12600k vs i5-13400?) recommendations, do not reply with non-Intel recommendations. Commenting on a build pic saying they should have gone AMD/Nvidia is also inappropriate, don't be rude. Let people enjoy things.
-
CPU Cooling problems: Just like 95C is normal for Ryzen, 100C is normal for Intel CPUs in many workloads. If you're worried about CPU temperatures, please look at reviews for the laptop or CPU cooler you're using.
founded 11 months ago
MODERATORS
How do you mount the AIO?
Do you use a criss cross pattern system?
For example turn each screw a half a turn in an opposite pattern.
Do this until you feel a slight resistance on all screws.
Then use a quarter or less of a turn on each screw continuing in the opposite pattern.
You do this until the screws bottom out. This way you know that each screw has even pressure and the block is mounted evenly.
1.67v Vcore is insane you're going to degrade and kill your CPU in the less a year
1.35v is the normal range for 14700k could go lower or high depending on your luck.
Why are you running PL 1/2 at 4095 ? That's a recipe for heat , try intel specs or a bit over but not zero limits , I run 253 pl 1 and 2 with mce off , I might lose 5 percent over limitless but always below 80 usually cinebench 23 is 78 degrees max
Intel 13th & 14th in a nutshell alway too hot
Go into bios and look for fans hw/monitor something titled like that. Look for the header that your pump is plugged into and check that it's set on pump and not fan and running at full speed.
Put a more aggressive fan curve in bios, matter of face put the fan full power in bios at first, see the temps and make adjustments after
Before Undervolting and such. Which yes is good to do. You shouldn’t be having these issues on a stock system. You undervolt to reduce heat, improve performance, not to fix problems.
Are you in the latest bios? Wish I was more familiar with MSI. If you had a Asus I could tell you exactly what to look for.
Since you mentioned ASUS, I’ll take advantage of you here, if you don’t mind, and ask you a thing or two.
Finished my build a couple of days ago with 14700k on z690 hero, DDR5 6400 cl32 and AIO 360 (Deepcool LS720). Running C23, with all at stock and I had
- MCE off: close to 90c, C23 score just above 32000 -MCE on - limits off: I’d thermal throttle in less than 15 seconds! Abort test
So dove into websites and videos, and Reddit (thank you guys) and undervolted by -0.075 and also -0.1 -MCE on - limits off: I run C23 no issues for over 10 mins with a max temp of 81. The average is like 72. Score is 35634
Do you think this is how the system should run in your opinion? I almost would say that there’s south thermal headroom that might be worth increasing p-cores speed, but not sure that it’s actually worth it for gaming.
Appreciate your insight