this post was submitted on 02 Apr 2024
53 points (96.5% liked)

196

16593 readers
2226 users here now

Be sure to follow the rule before you head out.

Rule: You must post before you leave.

^other^ ^rules^

founded 1 year ago
MODERATORS
53
Crappy D20 [Rule] (files.catbox.moe)
submitted 8 months ago* (last edited 8 months ago) by [email protected] to c/[email protected]
 

After 250 rolls, 1 popped up 27 times. Or roughly 11% of the time.

I did this same test with all 17 D20's I have and 2 D20's from people in my DnD group.

This one was far and away the worst though I had more than I'd like with averages under 10.

Edit:

Here's the stats for the ones I tested

This excludes the data for the 2 D20's from the people in my DnD group as they didn't want that data shared outside of the group chat.

top 10 comments
sorted by: hot top controversial new old
[–] [email protected] 15 points 7 months ago

A set of 250 throws with average of 9.56 in a fair d20 has a probability of about 0.5% to occur, so in 17 sets there is about a 8% chance to happen if you dice were fair according to binomial distribution. This means there is a 92% chance that your die is unfair. usually a confidence of >95% is needed for science but for home i think is enough to declare a dice unfair.

This calculation only says if the die is unfair, not how much unfair.

[–] [email protected] 12 points 8 months ago

250 rolls is really low for a d20 test, not enough to spread out the randomness over all surfaces. 1000 is also on the low side, but has more chance to indicate a bias.

[–] [email protected] 10 points 8 months ago

Very interesting statistical data set you have there, I'd be interested in replicating the outliers (particularly that 27 1's die) and if it isn't poorly shapen, don't reveal the follow-up stats and force the "cursed die" onto special rolls/annoying people in the party. If it is poorly shaped get rid of it imo,

[–] [email protected] 9 points 8 months ago

Naughty d20s go in the microwave.

[–] [email protected] 5 points 8 months ago

Oof that’s horrendous. Like the average is still around the same but the consequences are so so much worse

[–] [email protected] 3 points 7 months ago

I should open an Etsy shop and sell shitty d20s and not tell anyone. April fools!

[–] [email protected] 3 points 8 months ago

This is some hot data

[–] [email protected] 2 points 8 months ago* (last edited 7 months ago)

Now I think you should test if averages hold consistent between same sided die from different manufacturers. I think another poster is right that the shape matters, so if the die from the same caster are molded roughly the same, then they’ll present with similar averages.

[–] sirleonelle 1 points 7 months ago (1 children)

Looks like a bubble issue. Did you do the salt water test as well?

[–] [email protected] 2 points 7 months ago

Haven't done the salt water test mostly because I just wanted to see results before I did a test like that