No, that’s a mallet…
this post was submitted on 19 Jan 2024
16 points (100.0% liked)
Machinist
640 readers
8 users here now
From Newcomers to Old Timers, a community united by the Industry of Machining
Rules Don't post illegal stuff
Don't post Porn (no sexy aluminum surface finishes don't count)
Don't be an asshat (harassment, bullying etc.)
If you're going to post NSFW stuff, flag it as NSFW, It's ok to post shop Screwups (blood/cuts) just make sure to flag it as NSFW
and Finally make sure to have a good time :D
founded 1 year ago
MODERATORS
I worked at a shop for about 6 years where none of the operators were ever trained on how to properly mix coolant and management didn't care. Trust me, it can be a lot worse. I had to rip apart one vise where the internal hemisphere which mates with the set screw had been completely eaten away by rust.