Mechanical Keyboards

8877 readers

7 users here now

Are you addicted to the clicking sounds of your beautiful and impressive mechanical keyboard?
If so, this community is for you!

Here you can discuss everything about mechanical keyboards (and only mechanical keyboards).

Banner by Jay Zhang on Unsplash

founded 4 years ago

Is there a type of switch that is closer to a chiclet in terms of travel distance? (social.graves.cl)

submitted 9 months ago by [email protected] to c/[email protected]

9 comments fedilink hide all child comments

Is there a type of switch that is closer to a chiclet in terms of travel distance?

What about in terms of sound? I tried some kailh and they still felt a bit too long. Any suggestion?

cc @[email protected]

you are viewing a single comment's thread
view the rest of the comments

[–] Reverendender 1 points 9 months ago (1 children)

I would be interested in your take on the Redragon Horus

[–] [email protected] 2 points 9 months ago (2 children)

@[email protected] idk, tbh I’m interested in building or buying something like a corne but that is very silent and low profile.

The problem is that I’m super ignorant when it comes to keyboards 😅

[–] Reverendender 3 points 9 months ago

I'm just getting started myself, but I am traveling down this rabbit hole very quickly!

[–] xzot746 3 points 9 months ago (1 children)

I'm building a low pro Corne, Kailh browns with ChocFox keycaps, it'll be my travel keyboard.

[–] [email protected] 1 points 9 months ago (1 children)

@[email protected] my confer is that I work next to other people, are browns silent enough?

Btw where are you getting the pieces? Curious about your process

[–] xzot746 2 points 9 months ago

I cannot comment on the noise of the Kailh browns at the moment as the board has been giving me some grief and I am waiting on new Elite-C controllers from Omega Keys. The keycaps came from ChocFox, the PCBs were ordered directly from JLCPCB using Foostans design, everything else was mainly through amazon. As for the acrylic, I have my own CO2 laser and just cut them out of 1.5mm clear, also from Foostans GitHub repository.

There are several good tutorials out there with parts lists and the build process, Marek Piechut has a good one called Corne MX 3.0 Keyboard Build Guide.

I wanted something super thin so soldered the controller to the board, I do not suggest this as I had some errors on my part and destroyed the controller, thus I'm waiting for two new ones before I can use the board, until then I'm stuck with my hand wired dactyl manuforms.

Just make sure you know what board and keycaps you want, sounds like the Corne chocolate to me, and pay close attention to the LEDs if you go that route, I have 600 that are of no use to me and am waiting on the proper ones.

Other than that have fun and there are plenty of people willing to offer help and advice between here and Discord.