3DPrinting

15766 readers

34 users here now

3DPrinting is a place where makers of all skill levels and walks of life can learn about and discuss 3D printing and development of 3D printed parts and devices.

The r/functionalprint community is now located at: or [email protected]

There are CAD communities available at: [email protected] or [email protected]

Rules

No bigotry - including racism, sexism, ableism, homophobia, transphobia, or xenophobia. Code of Conduct.
Be respectful, especially when disagreeing. Everyone should feel welcome here.
No porn (NSFW prints are acceptable but must be marked NSFW)
No Ads / Spamming / Guerrilla Marketing
Do not create links to reddit
If you see an issue please flag it
No guns
No injury gore posts

If you need an easy way to host pictures, https://catbox.moe may be an option. Be ethical about what you post and donate if you are able or use this a lot. It is just an individual hosting content, not a company. The image embedding syntax for Lemmy is ![](URL)

Moderation policy: Light, mostly invisible

founded 2 years ago

MODERATORS

[email protected]

Advice on first 3D printer (lemmy.dbzer0.com)

submitted 10 months ago by [email protected] to c/[email protected]

32 comments fedilink hide all child comments

I am looking to purchase a 3D printer as a hobbyist, not for any commercial use. I have limited options with local 3D printers but that's good as they're mostly cheaper low end printers so I can look at them thoroughly.

When I'm comparing the different 3D printers I'm mainly looking at the following: Cost, nozzle diameter, layer height, volume, and viable filaments.

My question is, is there anything else I'm missing? Are there important things I should be considering or avoiding?

Different printers have different resolutions but for my purposes it looks like they're all highly accurate and way past what I need. Not worried about speed either. They all mention bed and nozzle temperatures but I assume they are all within the necessary range for the filaments they allow right? So does it matter?

Also, any advice for maintenance? How to make it last as long as possible any mistakes I should be wary of. Thanks.

you are viewing a single comment's thread
view the rest of the comments

[–] robotopera 0 points 10 months ago

We jumped in with 5x of the ender 3 s1s. I can't recommend them enough. After very little calibration and upgrading to a pei bed, they ran flawlessly for ~18 hours a day for 2 months straight.