homeassistant

12129 readers

7 users here now

Home Assistant is open source home automation that puts local control and privacy first. Powered by a worldwide community of tinkerers and DIY enthusiasts. Perfect to run on a Raspberry Pi or a local server. Available for free at home-assistant.io

founded 2 years ago

MODERATORS

[email protected]

Smart button not near zigbee hub (lemmy.nz)

submitted 10 months ago by [email protected] to c/[email protected]

28 comments fedilink hide all child comments

I'd like to add a smart button to my HA setup. I don't have zigbee signal nearby, so I'm wondering what the best way to do this would be.

I'm using a Skyconnect dongle. There's wifi nearby. I want to control a smart switch nearby, which would also have zigbee but that also wouldn't reach the distance I need.

Is Matter a solution here? With a hub connected to wifi that bridges to the button?

Any suggestions on hardware?

Or any other suggestions?

you are viewing a single comment's thread
view the rest of the comments

[–] [email protected] 2 points 10 months ago* (last edited 10 months ago) (1 children)

Yeah, it shouldn't need anything more than USB power, it's just another node in the mesh at that point. If you don't have one of those USB outlets just use a phone brick, that should be enough.

EDIT: See THIS for more info. While that's obviously written for Z2M some of it applies to other coordinators.

[–] [email protected] 1 points 10 months ago (1 children)

Sweet, I'll have a think of where I could put one. Any idea of range for ones that have an antenna?

[–] [email protected] 2 points 9 months ago (1 children)

The product page for the sonoff dongle says 40-50 meters line-of-sight but it'll depend on your walls and wifi interference.

[–] [email protected] 1 points 9 months ago

Oh cool, thanks. None of the ones I looked at showed range info that I could see. It has to travel through a few walls, but I'm sure one will do the job with the right placement.