this post was submitted on 22 Jun 2023
13 points (100.0% liked)
Bicycles
3126 readers
16 users here now
Welcome to [email protected]
A place to share our love of all things with two wheels and pedals. This is an inclusive, non-judgemental community. All types of cyclists are accepted here; whether you're a commuter, a roadie, a MTB enthusiast, a fixie freak, a crusty xbiking hoarder, in the middle of an epic across-the-world bicycle tour, or any other type of cyclist!
Community Rules
-
No bigotry - including racism, sexism, ableism, homophobia, transphobia, or xenophobia.
-
Be respectful. Everyone should feel welcome here.
-
No porn.
-
No ads / spamming.
-
Ride bikes
Other cycling-related communities
founded 1 year ago
MODERATORS
you are viewing a single comment's thread
view the rest of the comments
view the rest of the comments
Aligning the Alfines involves putting them into 4th gear and turning the fine adjustment on the shift until the yellow lines on the hub line up. It can easily be done every time you plan to use the bike. It is just easy to forget to do.
As for dealing with wheel re-installation and shifter cable reattachment , I customized a spanner to perfectly fit between the hub and the dropouts to either hold the hub in place while tightening the axle nuts or loading tension when installing the when reconnecting the shifter cable. I can't remember which. It might have been both.
After having failure issues using an Alfine 11 with a 29+ MTB (high torque setup), I have used nothing but cassette based drivetrains on everything but my folding bike. Also, my only local hub re-builder has stopped providing that service and Universal Cycles stopped carrying replacement internals, so I will probably not use an Alfine IGH on any new bikes.