From Newcomers to Old Timers, a community united by the Industry of Machining
Rules Don't post illegal stuff
Don't post Porn (no sexy aluminum surface finishes don't count)
Don't be an asshat (harassment, bullying etc.)
If you're going to post NSFW stuff, flag it as NSFW, It's ok to post shop Screwups (blood/cuts) just make sure to flag it as NSFW
and Finally make sure to have a good time :D
Hello this is my first time here. We search for new milling distributor around my place (Indonesia). We did found this strange looking milling machine. This look different from another. They use somekind of electrical rotor or idk. I wonder if anyone know this particular design. Would this work great or nah?
We had one where I used to work and it was fine I guess. They're basically drill presses with a table for the x and y. I will say get a version with the R8 chuck if you decide on these.
R8 is the only collets I accept. Why do there have to be so many kinds of collets!!!
No 5C? No 50 taper? What about ER collets? Different, non-interchangeable sizes because fuck everyone I guess.
"Guys I need a way to hold a tool!!!" Catapiller-we made a cat collet Fritz Weber- here's your er8
Etc... everybody kept solving a problem that was already solved