this post was submitted on 23 Sep 2023
116 points (98.3% liked)
Asklemmy
43940 readers
379 users here now
A loosely moderated place to ask open-ended questions
Search asklemmy ๐
If your post meets the following criteria, it's welcome here!
- Open-ended question
- Not offensive: at this point, we do not have the bandwidth to moderate overtly political discussions. Assume best intent and be excellent to each other.
- Not regarding using or support for Lemmy: context, see the list of support communities and tools for finding communities below
- Not ad nauseam inducing: please make sure it is a question that would be new to most members
- An actual topic of discussion
Looking for support?
Looking for a community?
- Lemmyverse: community search
- sub.rehab: maps old subreddits to fediverse options, marks official as such
- [email protected]: a community for finding communities
~Icon~ ~by~ ~@Double_[email protected]~
founded 5 years ago
MODERATORS
you are viewing a single comment's thread
view the rest of the comments
view the rest of the comments
When adjusting bicycle derailleur, use the second smallest and second largest cogs to adjust the shifting and the biggest and smallest ones only to adjust the limit screws. There's no point adjusting the cable tension if your derailleur is resting against the limit screw.
Thank you! I need to adjust mine, this is great advice!
Advanced tip is to remove the derailleur hanger and see against a flat surface wether it's straight or not. If not, and you don't have the calibration tool then just clamp it on a vice and use hammer/pliers/crecent wrench to bend it back straight. It's not going to be perfect but since it's already bent you're probably not going to make it worse either.
I've been on Team IGH for close to 15 years now. I sure don't miss adjusting derailleurs. But I'll remember this if I get a touring bike again.