3DPrinting

15130 readers

20 users here now

3DPrinting is a place where makers of all skill levels and walks of life can learn about and discuss 3D printing and development of 3D printed parts and devices.

The r/functionalprint community is now located at: [email protected] or [email protected]

There are CAD communities available at: [email protected] or [email protected]

Rules

No bigotry - including racism, sexism, ableism, homophobia, transphobia, or xenophobia. Code of Conduct.
Be respectful, especially when disagreeing. Everyone should feel welcome here.
No porn (NSFW prints are acceptable but must be marked NSFW)
No Ads / Spamming / Guerrilla Marketing
Do not create links to reddit
If you see an issue please flag it
No guns
No injury gore posts

If you need an easy way to host pictures, https://catbox.moe may be an option. Be ethical about what you post and donate if you are able or use this a lot. It is just an individual hosting content, not a company. The image embedding syntax for Lemmy is ![](URL)

Moderation policy: Light, mostly invisible

founded 1 year ago

MODERATORS

[email protected]

Melting 3D Printed eReader cases on my deck. (programming.dev)

submitted 11 months ago* (last edited 11 months ago) by [email protected] to c/[email protected]

29 comments fedilink hide all child comments

I made a 3d printable eReader case for my wife. Wanted to test what would happen if we water logged them and left them in the sun to dry.

Two of the cases are made from PLA while the other is made from PETG. They are all held together by thread and leather.

The test here is to see if moving from PLA to PETG was the right move since the last time I did this, the case turned into a banana.

My eventual plan once I've finished with my testing is to sell these cases and make their designs available for others to print.

you are viewing a single comment's thread
view the rest of the comments

[–] [email protected] 10 points 11 months ago

I don't think your particular case would have any creep as it's not mechanically leveraged in any real way.

If you were to print something like a cupholder for a stroller or bike where it's holding something up with some weight while in the heat is where you would notice it especially with repeated impact. Most likely wouldn't outright fail but under constant load you would notice it starting to bend a little. That said you can absolutely over engineer it to prevent that rather than switching materials which can be a huge pain depending on the printer.

I did my hydroponic tower in PETG but it honestly would've been ok in PLA since it's just a static fixture. I've had a PLA badge on my car for 3 years in 110+ summers and similar to you I've only noticed fading on the raised white lettering.