this post was submitted on 22 Aug 2023
21 points (100.0% liked)

VoronDesign

305 readers
1 users here now

lemmy.world community for VoronDesign 3D printers

founded 1 year ago
MODERATORS
 

Also got it belted up, but found out afterwards that I used a grease that is controversial on the rails (superlube with syncolor). It's recommended by LDO and Nero3D uses it in his video, but many folks on the Voron Discourse say it's a no-go. I'd rather not risk it, so I'm uninstalling the rails, cleaning/degreasing them, and reapplying some white lithium grease.

you are viewing a single comment's thread
view the rest of the comments
[–] [email protected] 2 points 1 year ago (1 children)

Thanks for the tips!

For the z-rails, how high are we talking? Manual is 3mm and that's what I stuck with initially, but I've got the rails off to clean and degrease/regrease then right now, so now's as good a time as any

[–] [email protected] 2 points 1 year ago (1 children)

I'm currently at about 6mm. It does leave a gap, but it's really not noticeable if you're not at a super low angle and it makes installing the covers so much easier

[–] [email protected] 2 points 1 year ago (1 children)

Cool cool. I printed a shim to get the right height, I'll just make it a bit taller. Thanks again

[–] [email protected] 1 points 1 year ago

If you have the printed parts already you can try installing one now to see how it goes, especially if you have the gantry off right now.