this post was submitted on 13 Jun 2023
3 points (100.0% liked)

Home Automation

2965 readers
1 users here now

Discussion about general home automation ideas and projects, home automation protocols like Z-wave, Zigbee, Matter, etc, and home automation software and hubs like HomeSeer, Home Assistant, OpenHAB, Homey.

founded 2 years ago
MODERATORS
[email protected]
3
Use excess Solar to run your pool pump (Node-Red & Home Assistant) (blog.grieve.com.au)
submitted 1 year ago* (last edited 1 year ago) by [email protected] to c/[email protected]
12 comments fedilink hide all child comments
 

I am in the process of building this in my system. I want to add a couple of extra features. such as minimum run time, the ability to run a few minutes each hour over night (for skimming) and some other bits an pieces.

you are viewing a single comment's thread
view the rest of the comments
[–] [email protected] 1 points 1 year ago

i think i want to try and run between the sunny hours, only off of solar. but at some point it will be obvious i wont get my minimum run time in, so i will need to run it anyway.

Shouldn't be too hard to track the sun in the sky, and start the solar-powered run when it is above an angle, and move to a maximum time limited schedule when it is not possible to actually generate enough power to run the pump.

  1. track the time that the pump is running, and reset it to zero at the start of the day
  2. when the solar allows for it, run the pump
  3. when solar is not longer able to power the pump (ie max potential power is less than trigger), move to a timer based schedule
  4. if the pump run time is >required, stop the pump (and dont restart it)