Electronics

2053 readers

1 users here now

Projects, pictures, industry discussions and news about electronic engineering & component-level electronic circuits.

Rules

1: Be nice.

2: Be on-topic (eg: Electronic, not electrical).

3: No commercial stuff, buying, selling or valuations.

4: No circuit design or repair, tools or component questions.

5: No excessively promoting your own sites, social media, videos etc.

Ask questions in https://discuss.tchncs.de/c/askelectronics

founded 1 year ago

MODERATORS

[email protected]

As a novice at soldering, I now have an opinion about single-sided vs. double-sided breadboards (lemmy.world)

submitted 5 days ago by [email protected] to c/[email protected]

17 comments fedilink hide all child comments

Me a few days ago, shopping on Amazon: "All the component and jumper wire leads are going to be on the bottom anyway; why shouldn't I get a pack of single-sided breadboards for $6.25 instead of double-sided ones for $10?"

Me today, after having lifted three pads off the damn board in 10 minutes: "Oh, that's why."

Get the double-sided breadboards; they're worth it.

you are viewing a single comment's thread
view the rest of the comments

[–] [email protected] 6 points 5 days ago

Probably double-sided prototyping PCBs. The double-sided ones tend to be green (FR4 fiberglass resin), the single-sided orange (FR2 paper phenolic-resin).

Terminology varies, a lot of greymarket sellers use "veroboard", "prototype board" and "breadboard" interchangeably.

The glue between the copper pads and the board itself tend to better with the double-sided boards, I agree with you OP :) Although this isn't universal, I've had some nasty bare copper boards on FR4 where the pads pop off when you try to solder to them; and some old FR2 boards with really well adhered pads. I've read somewhere that this might (?) be due to moisture in the PCB boiling off when you put the soldering iron to a pad and that baking the board in an oven first can help, but I have not tried that. I suspect a lot of it comes down to the quality of adhesive used between copper and substrate.