3DPrinting is a place where makers of all skill levels and walks of life can learn about and discuss 3D printing and development of 3D printed parts and devices.
The r/functionalprint community is now located at: [email protected] or [email protected]
There are CAD communities available at: [email protected] or [email protected]
No bigotry - including racism, sexism, ableism, homophobia, transphobia, or xenophobia. Code of Conduct.
Be respectful, especially when disagreeing. Everyone should feel welcome here.
No porn (NSFW prints are acceptable but must be marked NSFW)
No Ads / Spamming / Guerrilla Marketing
Do not create links to reddit
If you see an issue please flag it
No guns
No injury gore posts
If you need an easy way to host pictures, https://catbox.moe may be an option. Be ethical about what you post and donate if you are able or use this a lot. It is just an individual hosting content, not a company. The image embedding syntax for Lemmy is 
Moderation policy: Light, mostly invisible
So I set this text to change the bottom layer to concentric only for the text and I got this. I had this large flat area in my print and decided to spice it up a bit for fun without doing multicolor which would be 1, too annoying to do manually and 2, too visible for this part that needs to be all black. So here I have a nice DON’T PANIC on the back of it.
It isn't that bad. Just needs a bit of z-offset adjustment. Your comment isn't helpful as it's just an insult, not constructive criticism. Tell OP what they need to change to make their first layer not bad, don't just tell them it sucks.
PA is also way too low (if it is even set at all). It could reduce the „thickening“ of the lines at each end dramatically.
Z offset like you mentioned is probably wrong, extrusion multiplier is probably wrong, extruder might be incorrectly calibrated, PA is definitely wrong. It really looks like it hasn't received any tuning at all and this was just done with OTB defaults.