One painful firmware update later and the z-offset bug that has plagued me since getting the Neptune 4 Pro is finally resolved and first layers are good again just like that. I just had to share the thrilling end result.
this post was submitted on 17 Aug 2024
226 points (96.3% liked)
3DPrinting
15651 readers
186 users here now
3DPrinting is a place where makers of all skill levels and walks of life can learn about and discuss 3D printing and development of 3D printed parts and devices.
The r/functionalprint community is now located at: [email protected] or [email protected]
There are CAD communities available at: [email protected] or [email protected]
Rules
-
No bigotry - including racism, sexism, ableism, homophobia, transphobia, or xenophobia. Code of Conduct.
-
Be respectful, especially when disagreeing. Everyone should feel welcome here.
-
No porn (NSFW prints are acceptable but must be marked NSFW)
-
No Ads / Spamming / Guerrilla Marketing
-
Do not create links to reddit
-
If you see an issue please flag it
-
No guns
-
No injury gore posts
If you need an easy way to host pictures, https://catbox.moe may be an option. Be ethical about what you post and donate if you are able or use this a lot. It is just an individual hosting content, not a company. The image embedding syntax for Lemmy is 
Moderation policy: Light, mostly invisible
founded 2 years ago
MODERATORS
you are viewing a single comment's thread
view the rest of the comments
view the rest of the comments
It's not a little squished?
The perimeter does seem a little squished, but the lines making up the fill look pretty good. It could just be the lighting.
Too much squish = ripples and I don't see any of those.
I don't think it was squished, it came out without any of those ripples and the perimeter didn't have any elephant's foot.
Hella tight! Congratulations 🎉