Update: TL;DR: I cleaned the z-axis, replaced the nofep, installed the latest Chitubox (2.1) and cleaned up my profile to get it working
Hello, I hope someone will see this and be able to at least point me in the tight direction. As at this point I’m becoming desperate.
My Epax E10 4k is acting up, and I do not know why.
Part of the print is fine (see images) and then other parts are just stopped at a certain layer, with the rest stuck to the noFep.
I tried different prints, to make sure it wasn’t a layering problem, but alas… each single print suffered from the issue. The larger prints would ‘hang’ over non-printed layers…
I recalibrated my printer, changed the fep…
The one difference from before is the resin. I used to buy epax hard and tough, but my regular resin dealer doesn’t sell them anymore, heck it seems it is no longer available in europe. So I switched to the next best thing on the Epax compatibility list: eSun hard and tough.
Anybody have any clever idea?
Have all these prints been sliced at the same time? (Like on the same version of the slicer)
I had an issue on my filament printer where I thought it was messing up, so I tried a few different prints to make sure and it was still failing. But it turned out that it was caused by a buggy Cura update
So you think is is maybe a software issue?
I’ll check if there are any known issues and possibly update my chitubox
Well, it seems you might be right.
I installed the latest version of Chitubox Basic (2.1) and now it works just great.
Thank you very much, kind internet stranger!
No worries at all! Glad it's all sorted!