this post was submitted on 25 May 2024
64 points (100.0% liked)

Machinist

678 readers
2 users here now

From Newcomers to Old Timers, a community united by the Industry of Machining

Rules Don't post illegal stuff

Don't post Porn (no sexy aluminum surface finishes don't count)

Don't be an asshat (harassment, bullying etc.)

If you're going to post NSFW stuff, flag it as NSFW, It's ok to post shop Screwups (blood/cuts) just make sure to flag it as NSFW

and Finally make sure to have a good time :D

founded 1 year ago
MODERATORS
 

You can really see the difference few inches in

If it's stupid but it works it ain't stupid

you are viewing a single comment's thread
view the rest of the comments
[–] [email protected] 19 points 6 months ago (3 children)

Just dont accidentally get ur cutting fluid on the boards it will cause them to be extra frictiony and well now u have an industrial vibrator

[–] BigFatNips 4 points 6 months ago

Anything is a vibrator if you're brave enough

[–] mindbleach 3 points 6 months ago

For when you leave your shop on silent.

[–] [email protected] 2 points 5 months ago

I sprayed in some coolant and they didn't seem to stick any more then before, they just rock back and forth