I loved Tidal until I hit some arbitrary cap on the number of songs you can dislike. Cancelled after their support had no answer for why theres a limit.
dawnerd
joined 1 year ago
A lot of people went back, just as Reddit expected.
It’d be fun to mess around with if it wasn’t 12-18k for the setup.
It’s a bit overblown IMO. Unless you’re going wild with multi material it’s about the same as any other printer. Sure it purges a little even if you don’t change filament between prints but it’s still such a small amount. I found myself purging a little each time with my Prusa and Enders before too.
If you’re that worried don’t get an ams for multi color printing. Get an ams to reduce waste for automatic spool runout switching.
This is actually ewaste. The normal pencils have been on sale fairly often for 99 bucks and the price difference isn’t really enough so all they’re doing is making trash in an attempt to lure people into paying the small amount more for the better version.
This has been an issue for years though. Guessing either they made it worse or people just now noticing.
This IS the same guy that kept raising the price of FSD despite not delivering on promises.
Wow, that's not something I want to hear after just signing up for it (again). Something must have changed, I had flex pay years ago and an email to them for it cancelled no problem. Sounds like one of those ask them to change your payment method to a privacy.com or similar card and just block payments going forward until they figure it out and cancel.
Honestly don’t know either. Never had this happen before but surprisingly if I’m careful it prints fine if I don’t use the ams. 🤷
I would say the same but I have five rolls of theirs that no matter how long they dry they basically crumble apart, did it right from the bag too. So I dunno what’s up with their QC but that’s pretty bad.
Must have been test drives then, seen them driving around a bunch for a while now. LA is gonna be a real test of its capabilities for sure!
view more: next ›
Summer I really make sure they’re in vac bags with indicating desiccant. Winter not so worried. I used to just not care but since getting an X1C with ams I’ve had a number of rolls of pla snap inside and trying to clear that out is annoying. Haven’t really had an issue sense although I have some esun pla+ that is incredibly brittle and will snap just looking at it.