claude_flammang

joined 2 years ago
[–] [email protected] 1 points 1 month ago (1 children)

@lambda @homeassistant
Is there something affordable with Thread?

[–] [email protected] 2 points 3 months ago

@c10l EVE’s Energy have been providing energy metering under Matter for the last few months.

Ok, it was a HA specific solution.

[–] [email protected] 1 points 5 months ago

@pasqualeberesti @homeassistant
Cela dépend du serveur DHCP/DNS. Sur ma Fritzbox le nom était: “d0fef586960d4e3fad76d5a38d846fa4-hap.fritz.box”. Je devais donc d’abord le renommer.

[–] [email protected] 1 points 5 months ago

@retrieval4558
Yes, I was referring to schedules where you cannot use the sun. Sun related automations work very reliably for me.

[–] [email protected] 0 points 5 months ago (2 children)

@retrieval4558
As far as I can see, you can’t use the position of the sun as trigger.

[–] [email protected] 1 points 6 months ago

@semperverus
In European countries you only have live wire, never the ground, neutral in newer installations.
The switches don’t need ground as there is no exposed metallic component. Ground is needed where a human could be exposed to live (due to a fault) as it would trigger the breaker.

[–] [email protected] 1 points 6 months ago* (last edited 6 months ago)
[–] [email protected] 1 points 6 months ago (1 children)

@Passerby6497
Shelly Pro 1PM that I had lying around. Reports Amps usage fast enough to allow me to cut off electrical heating before the breaker cuts off because of overload.
This results in washer and heating alternating their power usage without triggering the breaker.
Home assistant OS on Raspberry Pi 4.

[–] [email protected] 1 points 6 months ago (1 children)

@sabreW4K3
Create a timer that you set to 5 minutes.
Create an automation with 3 triggers:

  1. Motion is detected
  2. Motion clear
  3. Timer changes to idle

Choice of three actions:

When 1:
Switch light on
Cancel timer (this takes care of motion being detected again during the 5 minute delay)

When 2:
Start timer (And let’s wait for 5. Minutes for timer to end)

When 3:
Check that motion is clear (as motion also cancels the timer)
If so, switch light off

[–] [email protected] 2 points 7 months ago

@barbarosa
For all those sensors (temp, current etc.) I always prefix the entity ID and friendly name with the area name.
I create areas like “kitchen fridge” or “garage fridge” to keep my stuff organized.

view more: next ›