I don’t have any 100% pictures cause I completed it at the same as my wife had our second baby and then started a new job at basically the same time and it was immediately a total mess.
Sam
I didn’t even know there was a spray brb gotta go get some
It’s LVP and pretty silent. This brand has a sort of honeycomb rubber backing that makes it all quite stable.
When I’m doing coding interviews I always like to start off and say I’m a big fan of very long variable names. “As descriptive as you can be” I say. Then I get to my first for loop. Instead of i I use “iterator” and then when I start a nested loop I use “jiterator” and it always gets a laugh.
I cut a few for inside but I’ve left most of them to complete their lifecycle.
This was while the electrical was still being hooked into the shed. I trenched in two conduits with cat6 Ethernet in one and one 20 amp and one 30 amp in the other. There are a few outlets inside running off the 20 amp circuit, as well as interior and exterior lighting, and a switched exterior weatherproof outlet. The 30 amp powers a single outlet for the space heater, which is entirely overkill for my 1800W space heater.
Tuffshed installs the shed as some modular walls bare stud with siding and roofing basically. I did everything after that other than the sheet rock.
When it’s fully upright yeah it wobbles a bit but I don’t mind it really.
It’s a VWINDESK, not sure what model or if they’re still in business. I’ve had it for a couple years now and I like it. It is strong enough to raise and lower with me (heavy) on top of it.
I had been meaning to get around to it forever but the bottom surface on this always stayed clean enough. Now that I got some I’m like everyone else who will tell you you should definitely get it.
I didn’t take a before picture cause it looked gross
No it’s usually cloudy with air bubbles from dissolved gasses