this post was submitted on 18 Nov 2023
1 points (100.0% liked)

Homelab

371 readers
9 users here now

Rules

founded 11 months ago
MODERATORS
 

As per the subject, can anyone recommend something affordable? I found 24 port Catalyst 3650 but they go not cheaper than £200.

top 13 comments
sorted by: hot top controversial new old
[–] [email protected] 1 points 10 months ago (2 children)

Also Aruba S2500, though recently ICX6450 have been cheaper. Both come in either 24 or 48 port flavors, with or without PoE.

Juniper EX4200 has the nice feature that even the non-PoE models support 8 ports of PoE. A bit louder than the above two, though.

[–] [email protected] 1 points 10 months ago

Juniper EX3300 is probably better. With 4 SFP+

[–] [email protected] 1 points 10 months ago

+1 for the S2500. 24 or 48 PoE ports, plus up to 4 SFP+

[–] [email protected] 1 points 10 months ago

Sorry for hijack the thread. What about routers? 10gbe downlink and uplink that support opnsense? I’ve seen a lot of n100 2.5gbe around 100$, would be awesome to see 10gbe nics or SFP+.

[–] [email protected] 1 points 10 months ago (2 children)

Mikrotik CRS328 24P-4S+RM

I have one - very quiet and power efficient.

[–] [email protected] 1 points 10 months ago

This.

It's a nice switch. Was an upgrade from a Zyxel.

[–] [email protected] 1 points 10 months ago

Can it do layer3 between vlans?

[–] [email protected] 1 points 10 months ago

Mikrotik CSS610-8P-2S+IN - $200
8x Gigabit PoE-out ports and 2x 10 Gigabit SFP+ ports.

Miktrotik CRS328-24P-4S+RM - $500
24 port Gigabit PoE with 4x 10Gbps SFP+ ports.

[–] [email protected] 1 points 10 months ago

Grandstream GWN7811P and 7812P. 2xSFP+ and 8 gigabit POE or 4xSFP+ and 16 gigabit POE, respectively.

[–] [email protected] 1 points 10 months ago

Cisco 3750X with the 10G NIM is also an option if you only need 2 uplinks. It's getting a bit dated though, but can be had for cheap.

[–] [email protected] 1 points 10 months ago (1 children)

Do you need 15, 30, 60 or 90w poe?

[–] [email protected] 1 points 10 months ago

30W should be enough, I have AP and couple of cameras, each consuming not more that few watts

[–] [email protected] 1 points 10 months ago

Powercoonect 5524p does layer 3 and has 10g if iirc.