Homelab

380 readers

9 users here now

Rules

Be Civil.
Post about your homelab, discussion of your homelab, questions you may have, or general discussion about transition your skill from the homelab to the workplace.
No memes or potato images.
We love detailed homelab builds, especially network diagrams!
Report any posts that you feel should be brought to our attention.
Please no shitposting or blogspam.
No Referral Linking.
Keep piracy discussion off of this community

founded 1 year ago

MODERATORS

[email protected]

SuperMicro MoBo won't post (alien.top)

submitted 11 months ago by [email protected] to c/[email protected]

6 comments fedilink hide all child comments

I had a cool little bare-bones server that had an x8 series mobo and I wanted to turn it into a NAS. I ended ordering a X11SSM-F board so that I could use some better hardware. From what I could tell it should be a simple swap, but I put everything together today and cant get the dumb thing to POST.

Ive tried unplugging everything but the PSU and send the power-on command from IPMI. I've tried with 4 sticks of ram, 1 stick and no ram. I never get a beep or fans or anything.

I bought this board off ebay and it came with a processor installed and was "pulled from a working system". If I can Verify that its DOA then I'm sure I can get a refund, but I want to make sure I test everything I can before going that route.

you are viewing a single comment's thread
view the rest of the comments

[–] [email protected] 1 points 11 months ago (1 children)

I’m in the same boat with an X10SDV. I went down the rabbit hole for ACPI and the super micro troubleshooting docs but I haven’t been successful. If you are accessing IPMI then you’re ahead of me.

I would check every single jumper and look for any obvious signs of short circuits like scorch marks.

Otherwise good luck!

[–] [email protected] 1 points 11 months ago (1 children)

Does it do anything? The x10sdv can be a pita to troubleshoot as there is nothing at all to diagnose without access to ipmi.

I've had multiple x10sdv, some had a corrupted bios, others were completely shorted, and they all had the exact same symptoms of powering on, but only spinning fans at Max and nothing else.

You can get a diagnostics card to read out the post codes, but it's hard to find and often not cheap if you can find it at all. Should be the AOC-LPC80-20 iirc, if you want to look for it. If you get anything at all that's not just 00, there's hope a bios rewrite can fix it.

[–] [email protected] 1 points 11 months ago

Thanks for the notes! I’ll look around for this post card. I have power and IPMI LEDs looking happy but only after I latch power by shorting the ATX connector to ground and skipping the power button header.