3D Printing

4386 readers

1 users here now

For everyhting 3D printing related.

Please be excellent to each other :)

Icon by Freepik, Banner photo by Thiago Medeiros Araujo

founded 4 years ago

MODERATORS

[email protected]

First glass bed failure with PETG (programming.dev)

submitted 1 year ago by [email protected] to c/[email protected]

13 comments fedilink hide all child comments

I have been printing with PETG on glass for a little while now, and have gone through almost an entire roll. Yesterday I had my first print stick so hard that it delaminated the glass :(. I stopped using hairspray as it made the prints not stick at all, and printing bare glass was just fine. But something about yesterdays print made the glass give up. Is this how PETG + Glass normally fails? Works perfectly for years, and then suddenly fails?

you are viewing a single comment's thread
view the rest of the comments

[–] [email protected] 1 points 1 year ago (1 children)

You might look into a smooth build plate. It can take the damage and just be replaced.

[–] [email protected] 1 points 1 year ago

I went with glass originally as it seemed at the time to be durable and therefore less waste. I don't want to generate extra waste. And those pei sheets dont look cheap :/

Thanks for the suggestion though, will keep it in mind