Homelab

380 readers

9 users here now

Rules

Be Civil.
Post about your homelab, discussion of your homelab, questions you may have, or general discussion about transition your skill from the homelab to the workplace.
No memes or potato images.
We love detailed homelab builds, especially network diagrams!
Report any posts that you feel should be brought to our attention.
Please no shitposting or blogspam.
No Referral Linking.
Keep piracy discussion off of this community

founded 1 year ago

MODERATORS

[email protected]

Server keeps rebooting after 2 seconds (alien.top)

submitted 1 year ago by [email protected] to c/[email protected]

2 comments fedilink hide all child comments

I have a supermicro X9DRH-7F I am using for an unraid server as my media server for the last 2 years. Recently I had a sudden failure and all it would give me was 'System Initializing...' or hours when trying to start. Given the lac of info, I suspected the MB, so I replaced it with the same model.

After replacing, I was getting the same error. Further researched revealed that my monitor was cutting off the right side of the total display. So hooked up a wider monitor and I could see the code 15. Research shows this is a generic code for CPU/Memory. So I replaced the memory. I was able to reboot past the system initializing and got to point where it said it could not find my drives and was asking to reconfigure. I declined.

So now I believe it was the memory and not the MB, I put the old MB in place. It reboots after 2 seconds during powerup. This is new behavior, so I checked all my jumpers, my power connectors, and made sure all cards were seated properly. No change

I am looking for a solution to the reboot upon powerup or how to get the new MB to recognize my drives so I don't lose the 3+ years of collecting media. Any thoughts, please and thank you

you are viewing a single comment's thread
view the rest of the comments

[–] [email protected] 1 points 1 year ago

I've got a different Supermicro board. I've noticed that it's extremely sensitive to SATA issues - if something isn't just right it doesn't boot or gets all kinds of wonky. A flaky cable is enough to cause issues.

I assume you've tried it with nothing but CPU, RAM, and video, but if not give it a shot.