this post was submitted on 01 Jul 2023
49 points (88.9% liked)
Trees
6740 readers
41 users here now
A community centered around cannabis.
In the spirit of making Trees a welcoming and uplifting place for everyone, please follow our Commandments.
- Be Cool.
- I'm not kidding. Be nice to each other.
- Avoid low-effort posts
founded 1 year ago
MODERATORS
you are viewing a single comment's thread
view the rest of the comments
view the rest of the comments
What kind of container do you use to soak em?
How many uses do you get before you replace the iso?
Sorry for all the questions. You managed to get them stupid clean and I’m terrible at it.
I have a very similar setup, I use 99% rubbing alcohol and Epsom salt as well. I'm a clean freak with my glassware so I do it every day, but it only takes a couple minutes. I boil some water, run that through all the percolators, then pour in a bit of alcohol with Epsom salt and do the same before hitting it with hot water one last time. Just slap some silicone bong caps on both sides and give it a few healthy shakes, the tar and shit comes right out.
Thanks so much for sharing your method! Seems like I’ll need to pick up some caps and a bag of Epsom salt.
No worries, happy to answer.
EDIT: Rinsing + shaking with super hot water afterwards is a must.
Thanks so much for sharing! Clearly it’s working for ya.
To add on to the OP, if you're cleaning any kind of bong or bigger bubbler, these are great. You fill the piece up with a good amount of salt and 91%+ isopropyl alcohol, use the caps to seal it and shake the shit out of it. Prior to ordering a few packs of those, I had always just taken some saran wrap, layered it a few times over the openings and rubber banded it in place to avoid any leaks when shaking.
These look really helpful, thanks for sharing. EDIT: Just ordered em!
That's awesome! They've been so convenient to use. I just recently tried out these as well, and they've been nice for cleaning ash catchers. Rather than soaking them in a bag of iso and salt, I filled the ash catcher, used the plugs on either end and just shook it.