Homelab

371 readers

9 users here now

Rules

Be Civil.
Post about your homelab, discussion of your homelab, questions you may have, or general discussion about transition your skill from the homelab to the workplace.
No memes or potato images.
We love detailed homelab builds, especially network diagrams!
Report any posts that you feel should be brought to our attention.
Please no shitposting or blogspam.
No Referral Linking.
Keep piracy discussion off of this community

founded 11 months ago

MODERATORS

[email protected]

10Gb low power rackmount switch options? (alien.top)

submitted 10 months ago by [email protected] to c/[email protected]

7 comments fedilink hide all child comments

Hi all

A year ago I replaced my Juniper EX4200 48T for a Mikrotik CSS326-24G-2S+ as it was silent and used a fraction of the power (12w vs around 300w!).

Unfortunately, the 10Gb performance on the Mikrotik has always been weak and its pretty much died after about a year.

Any suggestions for a rack mount switch that has 24/48 gigabit ports, 2-4 10Gb SFP+ ports and isnt super noisy? - Brand new cheap end or used ebay enterprise is fine.

ICX 6450-48P maybe looking like my best option so far?

you are viewing a single comment's thread
view the rest of the comments

[–] [email protected] 0 points 10 months ago (2 children)

Sounds like a 24port none poe is the one for me then! Thats only 10w more than the mikrotik

[–] [email protected] 1 points 10 months ago (1 children)

ICX 6450-48P

its a great switch, I have found nothing else out there to replace mine.

[–] [email protected] 1 points 10 months ago (1 children)

I did the dumb. I'm now looking to replace my non-PoE with a PoE to get rid of some injectors (I refuse to have more than one switch in an 18u rack).

[–] [email protected] 1 points 10 months ago

me either, I ended up with 5 cameras and 4 AP's.

[–] [email protected] 0 points 10 months ago (1 children)

No risk of dying after a year either, they cost a couple of grand when they were new and they're built like tanks. If the noise of the stock fan gets to you the Sunon Maglev KDE1204PKV3 is a good replacement. You need to pop out the two outside pins and swap them because the switch uses a non-standard pinout, but that takes about 30 seconds.

[–] [email protected] 1 points 10 months ago

Brocades definitely have a risk of dying after a year, I've got 2 6450s with about a dozen ports that only negotiate 100M now. Still nice switches though.