this post was submitted on 28 Jun 2023
481 points (99.4% liked)
196
16748 readers
2165 users here now
Be sure to follow the rule before you head out.
Rule: You must post before you leave.
founded 2 years ago
MODERATORS
you are viewing a single comment's thread
view the rest of the comments
view the rest of the comments
I strongly dislike how many times I've stripped a Phillips and used a die grinder to force it to become a flat. Torx is fine.
I used to restore "barn bikes", most of them were Japanese. It took me a while to figure out the difference between Japanese Industrial Standard (JIS) and Phillips screws. Of course over the years, a lot of the fasteners had already been cammed out by previous owners using a Phillips screwdriver in a JIS screw. I had to resort to the die grinder method far more than I'd have preferred.