this post was submitted on 04 Sep 2024
4 points (83.3% liked)
Cars - For Car Enthusiasts
3923 readers
80 users here now
About Community
c/Cars is the largest automotive enthusiast community on Lemmy and the fediverse. We're your central hub for vehicle-related discussion, industry news, reviews, projects, DIY guides, advice, stories, and more.
Rules
- Stay respectful to the community, hold civil discussions, even when others hold opinions that may differ from yours.
- This is not an NSFW community, and any such content will not be tolerated.
- Policy, not politics! Policy discussions revolve around the concept; political discussions revolve around the individual, party, association, etc. We only allow POLICY discussions and political discussions should go to c/politics.
- Must be related to cars, anything that does not have connection to cars will be considered spam/irrelevant and is subject to removal.
founded 1 year ago
MODERATORS
you are viewing a single comment's thread
view the rest of the comments
view the rest of the comments
Gm used to, Volvo and Ram currently offer them.
You would get rid of the starter since the electric motor can start the engine.
What are you talking about?
I suspect we're talking past each other.
If you're talking about the Chrysler/Jeep electric motor boost thing, that's not new - Eaton has made them for going on 30 years for semis.
But retrofitting... Look at the torque loads you're talking about. And the space required.
For example, starters use a lot of current and generate significant torque, for seconds at a time. They overheat quickly. Trying to retrofit a more capable electric motor would be a huge task. Hell, simply removing the starter on some V8s requires detaching a motor mount and lifting the engine, there's so little space.
It would be even worse for the alternator (which would really revert to using a generator). You'd have to reengineer the crank pulley setup (basically give the crank a mount plate like the rear does), as the key design is intended as a shear relief. And that means all new pulleys, etc. Take a look at what's required to install a an aftermarket supercharger on a V8, say for racing. And the street versions don't require the torque loads you're looking at with a useful generator.
To do this aftermarket, it would require being engineered on a per-engine-platform basis, at a minimum, and then also per vehicle, as space constraints and mounts vary so much.
Then looking at that cost, and materials, battery, cables, etc, there are better ways to spend money and resources to achieve, what exactly?
The belt for the etorque is pretty tame compared to some supercharger setups I’ve seen. Its packaging is about as much as an old a/c compressor.
Crank pulley setups are easy and common to replace or retrofit.
I’m familiar with what you’re talking about and don’t see the issue.
Have you ever retrofit anything to an engine?