this post was submitted on 10 Apr 2024
27 points (96.6% liked)
Machinist
639 readers
1 users here now
From Newcomers to Old Timers, a community united by the Industry of Machining
Rules Don't post illegal stuff
Don't post Porn (no sexy aluminum surface finishes don't count)
Don't be an asshat (harassment, bullying etc.)
If you're going to post NSFW stuff, flag it as NSFW, It's ok to post shop Screwups (blood/cuts) just make sure to flag it as NSFW
and Finally make sure to have a good time :D
founded 1 year ago
MODERATORS
you are viewing a single comment's thread
view the rest of the comments
view the rest of the comments
What's the lash? In other words, how clapped out is she? Enco is known for making skookum shit but there are hot suppers even venerable Unky Enky cannot swallow.
I'd check the collet to make sure it can still hold fast. Twist the working end back and forth with the gear engaged but not powered on, there should be a little take up before it moves but not too much. Check the gantry and really any moving bits for excess play or wear.
If I were local and could fitter in my shed I'd be a pig in shit to have a nice little hobby mill like that. You'll have to peck a bit at tool steel bt she'll happily work harden all the brass you can find to givver
Edit: I just noticed the pull down only tag on the downfeed. I wouldn't pay more than 550 for it, she'll need a bit of work.
https://www.practicalmachinist.com/forum/threads/enco-mill-pros-cons.198619/
ill keeper in mind for $550 thanks chief!
Oh cool, are you AvE?
Just the tip, and only for a minute
You're the head of his penis, but only for 60 seconds?
Why such interest in my gland' end wha?