this post was submitted on 21 Oct 2023
22 points (100.0% liked)
Ask Electronics
3326 readers
2 users here now
For questions about component-level electronic circuits, tools and equipment.
Rules
1: Be nice.
2: Be on-topic (eg: Electronic, not electrical).
3: No commercial stuff, buying, selling or valuations.
4: Be safe.
founded 1 year ago
MODERATORS
you are viewing a single comment's thread
view the rest of the comments
view the rest of the comments
Do you have a multimeter? Or other way of gauging the resistance of the new traces?
I don't know the specific product you've used, and my experience with conductive paints and glues is almost nonexistent. But what I remember is that it was neither useful as a glue or a conductor. So I suspect that the resistance of the trace is too great to be used for traces going into the 100s of mm.
If my suspicion is correct, then maybe you can fix it by using the paint to attach something with little resistance in parallel to the paint traces. Maybe stripping a multicore wire and using a single strand of copper, lay it down on the trace and paint over it? Or cutting the traces out of tinfoil and gluing them down to the existing traces with some of the paint?
I was thinking about using thin copper tape, it's cheap and it should be better that some graphite ink I hope,
Definitely better conduction than the paint. Just make sure that the tape isn't coated where it has to make a connection to the pads.