this post was submitted on 18 Jul 2023
24 points (96.2% liked)
Cast Iron
2005 readers
14 users here now
A community for cast iron cookware. Recipes, care, restoration, identification, etc.
Rules: Be helpful when you can, be respectful always, and keep cooking bacon.
More rules may come as the community grows, but for now, I'll remove spam or anything obviously mean-spirited, and leave it at that.
Related Communities: [email protected] [email protected] [email protected]
founded 1 year ago
MODERATORS
you are viewing a single comment's thread
view the rest of the comments
view the rest of the comments
As far as brand, I'm not that knowledgeable yet. One thing to look for is smooth surfaces. Older cast iron and good, more expensive, cast iron is smooth and easier to cook with.
Hmm, I wrote out a reply, but seems like it didn't post. My apologies if you get two versions of kinda the same thing.
If you buy a modern Lodge off the shelf, it will have a pebbly surface. This is from the sand they use to cast the iron when the piece is manufactured. And in the olden days, they used to have a second step of grinding that pebbly surface smooth so it was a better cooking experience brand new. Somewhere in the 60's, they stopped doing that as a cost saving measure (yay capitalism!)
That being said, your new Lodge skillet will get smooth with time and use. It may take a few months of daily use, or longer if you're not using it as often. But the seasoning will slowly fill in all those little hills and valleys, and it will smooth out with use. So more expensive manufacturers have added that stone grinding step back in, and they are nicer to work with straight off the shelf. But your Lodge will get there too with time and use.
Is it not better to sand/grind out the pebble surface than to let it fill in? I just bought a new lodge skillet for my 17 year old son. All of my cast iron has been purchased second hand or inherited so I never had to deal with this.
Hard to say when you're talking about modern manufacturer's that are still producing. I'm a hard no for any power tools in restoration of antique pieces, but those are old pieces that are not being made anymore. Any power tool that modifies an antique piece is a bit of history that can't be replaced.
But for a basic Lodge, if you feel comfortable enough with the tools and want to go for it, there's probably no real harm there. If you mess it up, you can replace it for not much money.