this post was submitted on 19 Aug 2024
99 points (93.0% liked)
Linux
48332 readers
447 users here now
From Wikipedia, the free encyclopedia
Linux is a family of open source Unix-like operating systems based on the Linux kernel, an operating system kernel first released on September 17, 1991 by Linus Torvalds. Linux is typically packaged in a Linux distribution (or distro for short).
Distributions include the Linux kernel and supporting system software and libraries, many of which are provided by the GNU Project. Many Linux distributions use the word "Linux" in their name, but the Free Software Foundation uses the name GNU/Linux to emphasize the importance of GNU software, causing some controversy.
Rules
- Posts must be relevant to operating systems running the Linux kernel. GNU/Linux or otherwise.
- No misinformation
- No NSFW content
- No hate speech, bigotry, etc
Related Communities
Community icon by Alpár-Etele Méder, licensed under CC BY 3.0
founded 5 years ago
MODERATORS
you are viewing a single comment's thread
view the rest of the comments
view the rest of the comments
I don't see any reason to use a Raspi instead of an used thin client for selfhosting.
They use about the same energy, but the Mini-PC has x86, which has better software support, has more ports, and runs more stable.
I have a RPI for my 3D-printer (Octoprint), and I will soon replace it with a "proper" PC, because it always crashes.
Raspberry Pis are good for very small appliances, but for anything more, they suck imo
They are what you make of them. I have three 3b+ units sitting upstairs, one of which runs my entire media stack, and the second is mostly just for Pihole, and the last is for general tinkering I might need. The pin array is awesome to have.
No one's arguing they are low performance (although a 5 is practically 5x the performance of a 3b+ unit), but they definitely don't suck
I don't even mean performance in terms of computing power.
RPIs are, imo, not meant as a server. It might (and will) work fine, but one of the main problems I have is the power supply. As soon as I send a more advanced print job to my RPI, it crashes. Even though I have the official power cord.
If it works for you - fine! I don't want to tell badly about them. They are great.
It's just that they are very inflexible.
Could be a bad board. I have a Pi 3B+ that intermittently crashes and shows insufficient voltage no matter what power supply is used.